ACTIVE FOR SAFETY AND COMFORT
    
Elastomer

Form parts made of Elastomer (caoutchouc)

 

Production process - compression-moulding
First the raw material is cut into small form parts with a weight according to material quantity needed to fill the mould. Then it is pressed with hydraulic presses. The heat which is needed for the vulcanization process is applied through the pressing mould. The time which is needed to achieve the vulcanization of the product depends on materials and temperature of the mould.

Production process - transfer-moulding
The transfer molding process is similar to the injection molding. The raw material is placed into the preheated mould. While closing the press the material is „injected“ through channels into the molding nests.

Production process - injection-moulding
Injection molding is made on special injection molding machines. The material is molded inside a special piston which plastifies and tempers during this process. The main advantages are reduced vulcanization cycles through even warm caouthchouc material and very high accuracy on measurements.


Raw materials
We use the following materials:

SBRStyrol-Butadien-Caoutchouc
EPDM  Ethylen-Propylen-Dien-Caoutchouc
CRChloropren-Caoutchouc
NBRNitril-Caoutchouc
QSilicon-Caoutchouc

Colors:

  • black
  • red
  • grey
  • transparent

hardness 50 through 90 shores A